Can be used with all BayStar helms, with appropriate fittings. Kit contains two cut lengths of tubing.
BayStar Tubing Kits:
20’ kit (2 x 20’ lengths tubing): HT4420H
30’ kit (2 x 30’ lengths tubing): HT4430H
(NOTE: BayStar Cylinders with H suffix must use tubing part number with H suffix.)

How to Measure Hydraulic Hoses

New Installation:

Measure hose routing path from wheel center line to engine connection, as follows:

A = Center line of wheel to gunwale (or deck, if routed downward),
B = Dash to transom,
C = Gunwale to centerline of cable connection at centered tiller.

Most cylinders move with the engine/rudder; enough slack must be left in hoses/tubing to prevent sharp bends (less than 3” radius) and/or kinking.

Where rigid tubing is used, flexible hoses must be installed between tubing and cylinder, to allow cylinder articulation.

For Most Cylinders, add A, B & C + 24”, round up to next even foot. Order that length hose kit, or twice that length in tubing.

Hose routings (such as those found on pontoon boats) may vary from this drawing. Confirm length by laying a garden hose along cable path and measure run from wheel to engine connection point.

Typical Single Station Routing

A single, front-mount outboard cylinder system is shown in this diagram.

If your hydraulic system is different than the one depicted and/or you have any questions about hydraulic steering after reviewing this guide, please contact SeaStar Solutions® Technical Service.