They are the same except the pro-fish has the automatic free-fall as standard. This is an optional extra on the pro-series windlass.

Yes. But you would have to purchase and fit a solenoid & rocker switch. Some of the small Lewmar / Simpson & Lawrence products are supplied without a solenoid. These units have the windlass power switched directly through a high current toggle switch. The high current toggle switch should be removed and replaced with a solenoid & rocker switch. The wireless remote can then be wired to the solenoid in parallel with the rocker switch.

Yes. V1/2/3/4/5 & H2/3, come with magnet and sensor fitted as standard. In most cases older Lewmar windlasses are pre-drilled to take magnets and sensors. Lewmar have a range of chain counters for use with our windlasses,

Yes. Lewmar recommends that when mooring, the rode is attached to a suitable strong point. If using a rope / chain rode then the rope should be tied off to a cleat or suitable strong point. If using a chain only rode then a chain stopper should be used. If the load is left on the windlass during mooring, shock loads could lead to damage of rode or the windlass. With rope rodes left under load in the gypsy the rope can get jammed into the gypsy causing damage to the stripper & rode when next operated. There is also a risk that the clutch nut could come loose causing the boat to slip its mooring.

Yes, it is possible to convert any of the H2/3, Concept / Ocean 1/2/3 and V2/3/4/5 range deck units to, or from a Gypsy Capstan. All you need to do is drop/remove the motor gear box. Take the circlip of the bottom of the shaft and replace it with the new shaft and then replace the circlip and motorgear box. You should not have to remove the deck unit.

Lewmar recommends a premium quality, windlass grade, medium lay, 3-strand nylon rope or a premium multi-plait nylon anchor rode. There are many different rode applications based upon windlass, anchor size, rode length and the anchor locker's depth and volume. For a list of recommended rode choices for your Lewmar windlass please see selection guide below.

Fall safe is a safety feature we have added to our new products. It is used in two ways. When the anchor is stowed, Fall-safe should be engaged to stop accidental deployment of the anchor. For windlasses not fitted with Fall-safe, an anchor safety strap or similar should be used. Fall-safe pawl should also be engaged during manual recovery to act as a ratchet.

Yes. Lewmar have recently added a 3 button windlass & 5 button windlass / thruster wireless remote to its range. These can be used on any windlass / thruster that is operated via a solenoid. The wireless remote is simply wired in parallel with the standard switch.

Due to the size and construction of the Pro-Series, it is not prepared for the installation of a chain counter. This does not stop the enthusiastic owner having ago but Lewmar cannot help with the installation or provide recommendations.

Most Lewmar windlasses have a manual recovery option however the method varies across the product ranges. Some Lewmar windlasses have built in manual recovery and others require an emergency manual recovery kit. Please consult your windlass manual for clarification.

Yes, all Lewmar windlasses have a manual free fall function as standard. To free fall the anchor, you simply manually undo the top nut half a turn. This releases the gypsy allowing it to free wheel. You can control the speed or stop the descent by re-tightening the top nut. Some of the larger windlasses with brake bands fitted work slightly differently. Please consult the manual for free fall operation.

Lewmar's range of windlasses allows the drum to be operated separately from the gypsy (independent warping). Once the primary rode is secured, the clutch nut can be slackened off ½ a turn. Now when the windlass is operated, only the drum will turn. This means that you can use the drum when docking or for a secondary rope only rode.

Yes, All of Lewmar's High volume ranges of products take rope and chain in the gypsy. The gypsy's are design to take a range of chains and ropes without the need to remove the rope or chain from the gypsy during recovery. This means you can use a spliced rode effortlessly, reducing both weight and cost of the rode. Check the rope/chain chart in the windlass section of the catalogue or your windlass manual for the correct rope/chain and gypsy match.

Yes, Lewmar make a range of different size gypsies that will handle a wide range of good quality, calibrated chain. Check the rope/chain chart in the windlass section of the catalogue or your windlass manual for the correct rope/chain and gypsy match.