102 Actuator

Used with Troll'n Tab Kits prior to 2000
5/16" (.79 cm) mounting hardware
Stroke: 4-1/4" (10.8 cm)
Length overall: 14" (35.56 cm)
Length pin to pin: 13" (32.87 cm)
Diameter (upper housing): 2-1/2" (6.35 cm)
Mounting hardware: 5/16" (.79 cm) or Delrin Pin (Part #15087-001)

Part # (Superceded #)
# 15059-001 (102-2) 12 Volt w/6' (1.83m) leads with Deutsch connectors and mounting hardware(replacement length)

• Top cap gland seal sheaths the actuator cable outer jacket as well as both internal conductors for maximum waterproofing
• Corrosion proof Vandar mounts
• Stainless steel ram won't flex, even under extreme loads
• Double O-ring for maximum protection
• Ballscrew rotates freely on 12 ball bearings at both ends of its stroke so there's no need for complicated limit switches and clutches
• Self-locking ballscrew locks into position and will not drift
• Precision molded, powdered metal, high alloy gears provide high accuracy, high wear resistance, and high strength for long life
• Tough, high-torque motor easily transfers 750 lbs
• High-impact, ultraviolet resistant nylon 66, 50% glass fiber reinforced thermoplastic housing
• Corrosion proof Vandar cap and mount, stands up to severe loads

WARNING: This product can expose you to chemicals including Di-n-hexyl Phthalate, DnHP, which is known to the State of California to cause reproductive harm, and Vinyl Chloride which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.